Removal And Installation - (4WD): Removal
WARNING:
- When working on the high voltage system, the work should be performed by technicians who have completed the relevant training. A lack of understanding of the high voltage system can lead to serious accidents due to electric shock or short circuit.
- When working on the high voltage system or related components, be sure to observe and be aware of the HIGH VOLTAGE SYSTEM GENERAL SAFETY INFORMATION AND CAUTION . If not, it may cause serious accidents due to electric shock or short circuit.
- When working on high voltage system, make sure to check the Personal Protective Equipment (PPE) and HIGH VOLTAGE SHUT-OFF PROCEDURES .
- Remove the front motor and reduction gear assembly.
(Refer to Front Motor and Reduction Gear System - " FRONT MOTOR AND REDUCTION GEAR ASSEMBLY ")
- Remove the steering gear box (A) after removing the bolts.
Tightening torque:
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb.ft)
NOTE: When installing the steering gear box, pre-tighten all bolts and tighten to the specified torque.