Removal And Installation - Rear Motor: Installation

Install in the reverse order of removal.

NOTE: Make sure the quick connector is installed securely after installing coolant hose.
[Type A]

Make sure the quick connector (A) is installed securely.

Courtesy of KIA MOTORS AMERICA, INC.

[Type B]

Make sure that the quick connector protrusion (A) fits into the groove (B).

Courtesy of KIA MOTORS AMERICA, INC.

Fill with motor system coolant.
(Refer to Electric Vehicle Cooling System - " MOTOR COOLANT REFILLING AND AIR BLEEDING ")

NOTE: Perform "Electric Water Pump Control" to air bleeding using KDS when filling with coolant.
Refill the rear motor and reduction gear oil.
(Refer to Motor and Reduction Gear System - " REAR MOTOR AND REDUCTION GEAR OIL ")