Removal And Installation: Installation
- Install in the reverse order of removal.NOTE:
- Do not reuse the driveshaft lock nut.
- After tightening the driveshaft lock nut, caulk the lock nut to an appropriate depth (A) by using a chisel or suitable tool.
Caulking Depth (A):
1.5 mm (0.0590 in.) or more
- Press the brake pedal to prevent the driveshaft from rotating when tightening the driveshaft lock nut.
- The existing front driveshaft circlip should be replaced with new one (do not reuse).
- Check the alignment.
(Refer to Suspension System - " ALIGNMENT ")