Removal And Installation: Removal
WARNING:
- When working on the high voltage system, the work should be performed by technicians who have completed the relevant training. A lack of understanding of the high voltage system can lead to serious accidents due to electric shock or short circuit.
- When working on the high voltage system or related components, be sure to observe and be aware of the HIGH VOLTAGE SYSTEM GENERAL SAFETY INFORMATION AND CAUTION . If not, it may cause serious accidents due to electric shock or short circuit.
- When working on high voltage system, make sure to check the Personal Protective Equipment (PPE) and HIGH VOLTAGE SHUT-OFF PROCEDURES .
- Remove the crash pad center panel.
(Refer to Crash Pad - "CRASH PAD PANEL ")
- Remove the front center speaker.
(Refer to Body Electrical System - " SPEAKER ")
- Remove the multifunction switch.
(Refer to Body Electrical System - " MULTIFUNCTION SWITCH - REMOVAL AND INSTALLATION ")
- Remove the Particulate Matter (PM) sensor.
(Refer to Heating, Ventilation and Air Conditioning - "PM SENSOR - REMOVAL AND INSTALLATION ")
- Disconnect the duct sensor connector (A).
- Disconnect the crash pad antenna connector (A).
- Disconnect the front midrange speaker connector (A).
- Remove the passenger airbag bolts (A).
- Disconnect the passenger airbag connector (A).
- Remove the main crash pad assembly (A) after removing the bolts and nuts.
Tightening torque:
17.7 - 23.5 N.m (1.8 - 2.4 kgf.m, 13.0 - 17.4 lb.ft)
[LH]
[RH]