Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

G13685944

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Connect VMI to KDS and launch the oscilloscope (2 channel) Ignition "ON".	PCM connector	6 (P-CAN high)	Chassis ground	-	Fig.1
	PCM connector	7 (P-CAN low)	Chassis ground	-	Fig.1
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	PCM (component side)	6 (P-CAN high)	PCM (component side)	7 (P-CAN low)	Approx. 120Ω
	ICU (component side)	17 (P-CAN high)	ICU (component side)	18 (P-CAN low)	Approx. 120Ω
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) of all concerned component to the related CAN system.	PCM connector	6 (P-CAN high)	Chassis ground	-	∞ (infinity)Ω
	PCM connector	7 (P-CAN low)	Chassis ground	-	∞ (infinity)Ω

G13685945

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to next procedure.
Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.

No Good

Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.

Module Circuit Inspection
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	PCM connector	5 (Memory power)	Chassis ground	-	B+
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	PCM connector	51 (ON/START Input)	Chassis ground	-	B+
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	PCM connector	1, 4, 25, 48 (ground)	Chassis ground	-	Approx. below 1Ω

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.