DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connector connection
- Faulty output speed sensor circuit
- Faulty output speed sensor
|
| Enable Conditions |
- Battery voltage is higher than 10V
- Engine speed higher than 400 RPM
- Vehicle speed is higher than 50km/h
- Shift lever position in "D" or "Sports" (Forward gear)
|
| Threshold Value |
- Vehicle speed equivalent to output speed is less then vehicle speed * 0.3 or higher than vehicle speed * 1.7 (ex. Less than 15km/h (9mph) or higher than 85km/h (53mph) when vehicle speed is 50km/h (31mph))
|
| Fail Safe |
- Prior to fault confirm: Gear fixed at current range, output speed backup signal is fixed at 5th gear
- After fault confirm: Manual gear shift from 2nd to 5th is allowed Gear is fixed at 5th gear at 'D"
Output speed back-up signal output adaptive
Learning is prohibited |
| Detecting Time |
|
| MIL ON Condition |
|