LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento X-Line EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Cooling System - 2.5 (VIN C) (Except HEV)) >> Cooling Fan >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch "OFF" and connect the KDS to the Data Link Connector.
  2. With the gear shift in P (Park) position and ignition switch "ON" (LED of the Power button illuminates in Red), select the "force drive" function.
  3. Force drive the cooling fan motor.

    Information 

    There are two functions for the fan motor force drive: Low speed and high speed.

    [Fan motor low speed] 

    1. Start the "Fan motor low speed" of the force drive function.
      G13660534Courtesy of KIA MOTORS AMERICA, INC.
    2. Force drive by pressing the start button.
    3. Visually check the operation of the cooling fan.
    4. Stop the force drive by pressing the stop button.
      G13660535Courtesy of KIA MOTORS AMERICA, INC.

    [Fan motor high speed] 

    1. Start the "Fan motor high speed" of the force drive function.
      G13660536Courtesy of KIA MOTORS AMERICA, INC.
    2. Force drive by pressing the start button.
      G13660537Courtesy of KIA MOTORS AMERICA, INC.
    3. Visually check the operation of the cooling fan.
    4. Stop the force drive by pressing the stop button.
      G13660538Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals