DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Performance monitoring	Poor connection Short to power of RPS signal circuit Restricted fuel return line Damaged RPS Damaged FPCV
Enable Conditions	Case1	Fuel flow setting value is between 4 and 136mg/stroke Difference of fuel flow setting value is between -25 and 25mg/stroke
Enable Conditions	Case2	Engine speed is between 512 and 7008 RPM Engine speed is greater than 768 to 960 RPM after engine "ON"
Threshold Value	Case1	Fuel rail and system pressure too high Fuel trim controller is between -50 and 50%
Threshold Value	Case2	Filtered fuel pressure is greater than 33000 kPa
Diagnostic Time	Case1	8s
Diagnostic Time	Case2	2s
MIL ON Condition		2 driving cycle