DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connector connection
- ATS
|
| Case 1 |
Enable Conditions |
- Battery voltage is between 11 and 16V
- Engine speed is between 768 and 960 RPM
- Vehicle speed is higher than 40km/h (24.85MPH)
|
| Threshold Value |
- Failure diagnosis if the ATS value is greater or smaller than the temperature value modeled during cold and hot periods: Difference of ATS value and model value is greater than 20°C (68°F)
|
| Diagnostic Time |
|
| Case 2 |
Enable Conditions |
- Battery voltage is between 11 and 16V
- At least 6h after engine "OFF"
- Engine coolant temperature reduction is below 1.4°C (34.5°F) when after engine "ON" and the vehicle speed is more than 25km/h (15.53MPH) and for 15s
- Intake, engine oil and ambient temperature reduction are below2.0°C (68°F) when after engine "ON" and the vehicle speed is more than 25km/h (15.53MPH) and for 15s
- ATS is greater than -30°C (-22°F)
|
| Threshold Value |
- Failure diagnosis if the ATS value is greater or smaller than the temperature value modeled during cold and warm up periods: Difference of ATS value and intake, engine coolant temperature model value is greater than 25°C (77°F)
|
| Diagnostic Time |
|
| MIL ON Condition |
|