Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
ATS (component side) | 1 (signal) | ATS (component side) | 2 (ground) | TABLE 1 |
ATS OF SPECIFICATION
| Temperature (°C (°F)) | Resistance (kΩ) | Temperature (°C (°F)) | Resistance (kΩ) |
|---|---|---|---|
| -30 (-22) | 480.41 | 20 (68) | 37.32 |
| -20 (-4) | 271.21 | 30 (86) | 24.26 |
| 0 (32) | 95.1 | 40 (104) | 16.13 |
| 10 (50) | 58.5 | 50 (122) | 10.95 |
Good
- Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the ATS and go to "VERIFICATION OF REPAIR " procedure.