Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
HO2S (Bank 1, Sensor 2) connector | 3 (power) | Chassis ground | - | B+ |
|
HO2S (Bank 1, Sensor 2) connector | 4 (heater) | Chassis ground | - | Approx. 2.5V |
|
HO2S (Bank 1, Sensor 2) connector | 4 (heater) | Chassis ground | - | ∞(infinity)Ω |
Good
- Go to "COMPONENT INSPECTION " procedure.
No Good
- Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.