DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Deviation check between actual CAM position and CAM set-point position in case of changing set-point (slow response of actuator)
|
- Poor connector connection
- Faulty E-CVVT assembly
- Faulty intake E-CVVT assembly
|
| Enable Conditions |
- Camshaft set-point movement more than 16 degree CRK
- Engine speed at between 576 and 4992 RPM
- Engine oil temperature at between 68°F (20°C) and 248°F (120°C)
- Battery voltage at between 11V and 16V
|
| Threshold Value |
- Deviation between the actual valve and the target valve is below 4 degree
|
| Diagnostic Time |
|
| MIL ON Condition |
|