Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

Check the fuel filter for blockage
1. Remove the fuel pump and check filter debris and clogging of the fuel supply line.
Check the fuel level
1. If you run out of fuel significantly on ramp, it may be a factor of degradation of the fuel pressure.
Check low-pressure fuel supply line leakage and blockage
1. Low-pressure fuel supply line damage and blockage can be a factor of the fuel pressure drop.
Check low-pressure fuel line
1. To measure a fuel pressure in idle with fuel pressure measurement gauge
  - Specification : 480 to 520 kPa (4.9 to 5.3kgf/cm² )
Good
- Go to "WIRING INSPECTION " procedure.
No Good
- Repair as necessary and go to "VERIFICATION OF REPAIR " procedure.