LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento X-Line EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine And Transaxle Assembly (R & I) - 2.5L (VIN C) (Except HEV)) >> Engine And Transaxle Assembly >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install in the reverse order of removal.
  2. Fill the coolant.

    (Refer to Cooling System - "COOLANT ")

    NOTE: The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.

    After installation, perform the following

    • Refill a radiator and a reservoir tank with engine coolant.
    • Inspect for fuel leakage.
      • After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
      • Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
    • Place a heater control knob on "HOT" position.
    • Clean the battery terminals and cable terminals with sandpaper, assemble them, and apply grease to prevent corrosion.
scientia non olet · About LEMON Manuals