Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Reference | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Starter relay (component side) | Relay coil power | Starter relay (component side) | Relay coil control | Approx. 80Ω at 20° C (68°F) |
Good
- Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the starter relay and go to "VERIFICATION OF REPAIR " procedure.