DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Signal monitoring	Poor connector connection Short or open circuit to ground in EGR actuator circuit EGR actuator
Enable Conditions	Case1	Ambient temperature sensor value is greater than -8.25°C (17.1°F) Vehicle speed is below 30km/h (18.6MPH) H-bridge control inactive
	Case2	Ignition "ON" Actuator PWM output is greater than -100% H-bridge control active
	Case3	Ignition "ON" Actuator PWM output is below 99% H-bridge control active
Threshold Value	Case1	Output resistance is greater than 200kΩ (ECU power stage diagnosis)
	Case2	Output current is greater than 15A (ECU power stage diagnosis)
	Case3	EGR valve driver is greater than 11A (ECU power stage diagnosis)
Diagnostic Time	Case1	Continuously
	Case2	Continuously
	Case3	Continuously
MIL ON Condition		2 driving cycle