Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Reference | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Fuel sender and fuel pump motor (component side) | 1 (fuel level sender +) | Fuel sender and fuel pump motor (component side) | 3 (fuel level sender -) | Table1 |
SPECIFICATION OF FUEL SENDER & FUEL PUMP MOTOR
| Float Position | Sender Resistance (Ω) | Capacity (l ) |
|---|---|---|
| L | 297 to 305 | 3 |
| 1/2 | 80 to 84 | 30.7 |
| F | 14 to 16 | 58.3 |
Good
- Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the fuel level sender and fuel pump motor and go to "VERIFICATION OF REPAIR " procedure.