DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Fuel filler cap missing
- Fuel vapor line stuck or damage
- Leakage in each hose, fuel filler pipe
- Leakage in CCV, canister, fuel tank
- FTPS
|
| Enable Conditions |
- Engine speed is between 768 and 960 RPM after engine "ON"
- Engine coolant temperature is higher than 45°C (113°F)
- Ambient temperature is between -8.25 and 54.75°C (17.1 and 130.5°F)
- Difference the pressure of fuel tank is between -1100 and 418Pa
- Fuel level is lower than 85%
- Integrated canister purge flow is more than 4.0g
- Vehicle speed is lower than 12km/h (7.4MPH)
- Barometric pressure is greater than 75 kPa
- Canister load is below 0.35
- Driving at least 60s at a speed of over 22km/h (13.6MPH)
- Engine idle
- Battery voltage is greater than 10V
- Fuel slosh is not detected
- Barometric pressure gradient during uphill driving within 15 minutes is below 7.5 kPa
|
| Threshold Value |
- Generated fuel tank pressure is below -1500Pa (low canister load) or below -300Pa (high canister load)
|
| Diagnostic Time |
|
| MIL ON Condition |
|