DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Check the state of change in fuel tank pressure due to PCSV and CCV operation
|
- Poor connector connection
- PSCV air leakage
- Fuel cap is damaged or uninstalled
- PSCV
- Canister
- Fuel tank pressure sensor
|
| Enable Conditions |
- Engine speed is higher than 768 RPM
- Engine coolant temperature is higher than 45°C (113°F)
- Ambient temperature is between -8.25 and 54.75°C (17.1 and 130.5°F)
- Difference the pressure of fuel tank is between -1100 and 418Pa
- Fuel level is lower than 85%
- Integrated canister purge flow is more than 4.0g
- Vehicle speed 0km/h (0MPH)
- Barometric pressure is greater than 75 kPa
- Canister load is below 0.35
- Driving at least 60s at a speed of over 22km/h (13.6MPH)
- Engine idle
- No related error
- Battery voltage is greater than 10V
- Fuel slosh is not detected
|
| Threshold Value |
- Estimated leakage diameter is greater than 0.81 mm
|
| Diagnostic Time |
|
| MIL ON Condition |
|