DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Signal monitoring	Poor connector connection Short or open in CKPS signal circuit CKPS Failure flywheel or sensor mounted plane Poor calibration for crankshaft or camshaft pulley
Enable Conditions	Case 1	Engine not in reverse rotation Crank teeth detected Crank reference gap undetected
	Case 2	Engine synchronized Engine speed is greater than 80RPM
	Case 3	Engine synchronized Engine speed is greater than 80RPM
	Case 4	Engine synchronized
Threshold Value	Case 1	The number of crank teeth is greater than 150 during no detection of the reference gap
	Case 2	Difference in number of teeth is more than 1 (additional teeth between two reference gap is greater than 1 or below -1)
	Case 3	Difference in number of teeth is more than 2 (additional teeth between two reference gap is greater than 2 or below -2)
	Case 4	Crank pulse width is greater than 130μs or below 70μs
Diagnostic Time	Case 1	10ms
	Case 2	2 revolutions
	Case 3	3 revolutions
	Case 4	0.04s
MIL ON Condition		2 driving cycles