Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Reference | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
CKPS connector | 1 (signal) | CMPS - In connector | 1 (signal) | Fig.1 |
| CMPS - Ex connector | 1 (signal) | E-CVVT connector | 2 (motor +) | ||
Good
- Fault migh tbe intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet.Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and go to "Verification of Repair " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Replace if necessary.
- Check a contact surface of the chain tensioner arm and guide for abnormal wear, cracks or damage. Replace if necessary.
- Check that the chain tensioner piston slides smoothly and inspect whether the ratchet operates normally. Replace if necessary.
- If no problems were found with the circuits or connectors, replace the CKPS and go to "Verification of Repair " procedure.