DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
Case1 |
|
- Poor connector connection
- Open or short in KS #1 signal circuit
- KS #1
|
| Enable Conditions |
Case1 |
- Knock control function active
- Engine coolant temperature is greater than 56°C (132.8°F)
- Engine Load is greater than 32%
- Mass air flow is greater than 250mg/stroke
- Engine speed during engine start is between 640 and 960 RPM
- Engine speed is greater than 2656 RPM
|
| Case2 |
- Knock control function active
- Engine coolant temperature is greater than 56°C (132.8°F)
- Engine Load is greater than 32%
- Mass air flow is greater than 250mg/stroke
- Engine speed during engine start is between 640 and 960 RPM
|
| Threshold Value |
Case1 |
- The voltage of filtered KS signal is below 0.195V
|
| Case2 |
- The Absolute value of the filtered knock sensor signal is below 0.059V
|
| Diagnostic Time |
Case1 |
|
| Case2 |
|
| MIL ON Condition |
|