DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
Case1 |
|
- Poor connector connection
- Open or short to power in signal circuit
- EOTS
|
| Case2 |
|
| Case3 |
|
| Enable Conditions |
Case1 |
- Engine speed is greater than 768 to 960 RPM at engine starting
- Oil temperature is higher than 71°C (159.8°F)
|
| Case2 |
- Engine speed is greater than 768 to 960 RPM at engine starting
- Oil temperature is higher than 49°C (120.2°F)
|
| Case3 |
- Battery voltage is between 11 and 16V
- At least 6h after engine "OFF"
- Engine coolant temperature reduction is below 1.4°C (34.5°F) when after engine "ON" and the vehicle speed is more than 25km/h (15.53MPH) and for 15s
- Intake, engine oil and ambient temperature reduction are below 2.0°C (35.6°F) when after engine "ON" and the vehicle speed is more than 25km/h (15.53MPH) and for 15s
- ATS is greater than -30°C (-22°F)
|
| Threshold Value |
Case1 |
- Oil temperature is below -40°C (-40°F)
|
| Case2 |
- Oil temperature is higher than 160°C (320°F)
|
| Case3 |
- Difference between the intake air temperature sensor value and the engine oil, ambient, engine coolant temperature model value is greater than 20°C (68°F)
|
| Diagnostic Time |
Case1 |
|
| Case2 |
|
| Case3 |
|
| MIL ON Condition |
|