Inspection Procedure

■ Check the fuel filter for blockage

1. Remove the fuel pump and check filter debris and clogging of the fuel supply line.

■ Check the fuel level

1. If you run out of fuel significantly on ramp, it may be a factor of degradation of the fuel pressure.

■ Check low-pressure fuel supply line leakage and blockage

1. Low-pressure fuel supply line damage and blockage can be a factor of the fuel pressure drop.

■ Check low-pressure fuel line

1. To measure a fuel pressure in idle with fuel pressure measurement gauge
   • Specification: 480 to 520 kPa (4.9 to 5.3kgf/cm² )

     Good 

     • Go to "WIRING INSPECTION " procedure.

     No Good 

     • Repair as necessary and go to "VERIFICATION OF REPAIR " procedure.