Injector Resistance Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
Injector connector (component side) | 2 (+) | Injector connector (component side) | 1 (-) | Approx. 1.425 to 1.575Ω at 20°C (68°F) |
Good
- Go to "Fuel System Inspection " procedure.
No Good
- Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to "Verification of Repair " procedure.
CAUTION:
- Install the component with the specified torque.
- Note that internal damage may occur when the component is dropped of mistreated.
CAUTION:
- Insert the sensor in the installation hole and be careful not to damage.