Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

■ Inspect whether to leak air or stuck

Inspect a contamination, gasket and installation
- Damaged or installation of throttle body
- Damaged or installation of intake manifold and gasket which is installed in surge tank
- Contamination and stuck in intake manifold
- Contamination between surge tank and PCSV and stuck open
- Damaged or contamination of O2S (up)
- Visual check leak a catalyst and a exhaust system of O2S (down)

■ Inspect whether to fuel line

Inspect a stuck, a contamination, a installation
- Check fuse line connection
- Check a installation of line, poor or damaged
- Damaged or cracked pipe
- Inspect a contamination of fuel filter
  Good
  - Go to "WIRING INSPECTION " procedure.
  No Good
  - Repair as necessary and go to "VERIFICATION OF REPAIR " procedure.