Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

G13680118

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	TPS connector	1 (ETC +)	Chassis ground	-	Approx. 1.6V
	TPS connector	2 (ETC -)	Chassis ground	-	Approx. 1.6V
	TPS connector	3 (TPS supply)	Chassis ground	-	Approx. 5V
	TPS connector	4 (TPS2 signal)	Chassis ground	-	Approx. 0V
	TPS connector	5 (ground)	Chassis ground	-	Approx. 5V
	TPS connector	6 (TPS1 signal)	Chassis ground	-	Approx. 0V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	TPS connector	6 (TPS1 signal)	Chassis ground	-	∞ (infinity)Ω
	TPS connector	4 (TPS2 signal)	Chassis ground	-	∞ (infinity)Ω

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair or replace as necessary and then, go to "VERIFICATION OF REPAIR " procedure.