DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Monitor the TPS1, 2 performance
|
- Poor connector connection
- TPS
- PCM
- Throttle body
- Throttle plate disorder
|
| Enable Conditions |
- Ignition "ON"
- TPS adaptation mode active
- MAFS or MAP sensor control is normal
|
| Threshold Value |
- Plausibility check between mass air flow through TPS1 and the corresponding TPS2 position
- The difference in the filtered air flow between TPS1 and the intake air flow is greater than 1.0
- The difference between TPS1 and the intake air flow is greater than 30
|
| Diagnostic Time |
|
| MIL ON Condition |
|