LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento X-Line EX >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Abs/ESC Diagnosis (Except HEV) (1 Of 4) >> DTC C1235-01: Pressure Sensor (Primary) - Open/Short >> Component Inspection >> DTC Check

DTC Check

  1. Ignition "OFF".
  2. Shift lever position "P".
  3. Engine "ON".
  4. Connect KDS and select "Diagnostic Trouble Codes (DTC)" mode.
  5. Using a KDS, clear DTC.
  6. Operate the vehicle within DTC detecting condition in "General Information".
  7. Select "Diagnostic Trouble Codes (DTC)" mode again.
  8. Is the same DTC stored in the system?

    Good 

    • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

    No Good 

    • Carefully re-do this troubleshooting guide steps.
    • If no problems were found with the circuits or connectors, replace the HECU and go to "VERIFICATION OF REPAIR " procedure.

      * In case of replacing HECU, perform "Vehicle S/W Management" procedure as component inspection of C110101.

scientia non olet · About LEMON Manuals