Circuit Inspection

G13666565

Courtesy of KIA MOTORS AMERICA, INC.

G13666566

Courtesy of KIA MOTORS AMERICA, INC.

Circuit Inspection (W/O EPB)
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	WSS FL connector	2 (signal)	Chassis ground	-	∞ (infinity)Ω
	WSS FL connector	1 (power)	HECU connector	12 (power)	Approx. below 1Ω
	WSS FL connector	2 (signal)	HECU connector	24 (signal)	Approx. below 1Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	WSS FL connector	2 (signal)	Chassis ground	-	0V
	WSS FL connector	1 (power)	Chassis ground	-	Approx. 11.5V
Ignition "ON".	WSS FL connector	2 (signal)	Chassis ground	-	0V
Ignition "ON".	WSS FL connector	1 (power)	Chassis ground	-	Approx. 11.2V

Circuit Inspection (With EPB)
Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	WSS FL connector	2 (signal)	Chassis ground	-	∞ (infinity)Ω
	WSS FL connector	1 (power)	HECU connector	28 (power)	Approx. below 1Ω
	WSS FL connector	2 (signal)	HECU connector	44 (signal)	Approx. below 1Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	WSS FL connector	2 (signal)	Chassis ground	-	0V
	WSS FL connector	1 (power)	Chassis ground	-	Approx. 11.5V
Ignition "ON".	WSS FL connector	2 (signal)	Chassis ground	-	0V
Ignition "ON".	WSS FL connector	1 (power)	Chassis ground	-	Approx. 11.2V

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.