| DTC Strategy |
|
- Poor connector connection and open or short circuit
- Wheel speed sensor connector and wire unstable connection
- Water flow into wheel speed sensor connector and wiring
- Open or short in wheel speed sensor circuit
- Faulty wheel speed sensor
- Faulty HECU
|
| Enable Condition |
|
| Threshold Value |
ESP |
- A failure is detected when the current of WSS is out of specified range of 4.5 to 20 mA longer than 0.2s
|
| EPB |
- When two or more WSS signals are faulty
|
| Warning Lamp |
|
| Disable Condition |
ESP |
- When all wheel speed is normal after driving more than 7.45MPH after the ignition switch turns off and then on
|
| EPB |
- When three or more WSS signals are normal
|