Repair Procedures: Replacement

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
Take care not to bend or scratch the trim and panels.

Disconnect the negative (-) battery terminal.
Remove the clips from the front bumper upper side.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the clips from the front bumper lower side.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the clips and screws on the side of front bumper, detach the side part of front bumper.
NOTE: When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

Courtesy of KIA MOTORS AMERICA, INC.
Separate the top of the front bumper (A) in the direction of the arrow.
NOTE: Be careful not to damage the fixing key (B) on the upper side of the front bumper.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the front bumper assembly (A).

Courtesy of KIA MOTORS AMERICA, INC.

Information

Remove the front bumper assembly (A) by holding the bottom and the side of the front bumper assembly and pulling it in the direction of the arrow.

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the front bumper fog lamp connector (A).
[LH]

Courtesy of KIA MOTORS AMERICA, INC.

[RH]

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the front bumper main connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector is connected in properly.
- Replace any damaged clips (or pin-type retainers).