| DTC Strategy |
- Prevent battery deterioration caused by over-charging
- Prevent accidents that can be caused by over-charging
|
- Faulty OPD power circuit
- Battery pack overcharging
- Poor contact in wire harness
- BMS
|
| Enable Condition |
- Turn the ignition switch "ON"
- Normal voltage range of auxiliary battery (9 to 16V)
- Diagnosis is unavailable due to over-charging (OPD deactivated)
|
| Safety Mode |
Power Derating |
Charge Power Limit |
|
| Discharge Power Limit |
|
| BMS State |
- Ready, controllable, warning
|
| Relay Control |
|
| Service Lamp |
ON Condition |
|
| OFF Condition |
|
| Set DTC |
|