Repair Procedures: Installation

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
Fill the coolant.

(Refer to Cooling System - "COOLANT ") and (Refer to Hybrid Motor System - "COOLANT ")

NOTE: The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.

Perform the following

Refill radiator and reservoir tank with engine coolant
Check for fuel leaks.
- After assemble the fuel line, turn on the ignition switch (Do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
- Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
Place a heater control knob on "HOT" position.
Clean the battery terminals and cable terminals with sandpaper, assemble them, and apply grease to prevent corrosion.