Monitor KDS Data
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | Inspection Procedure | Reference |
|---|---|---|
| 1. Ignition "ON". | 1. Connect KDS to "Data Link Connector (DLC)". 2. Ignition "ON". 3. Select correct vehicle model, year, and engine type with KDS. 4. Select "ALL" system.(1) 5. Select "Fault Code Searching".(2) |
Fig.1 to 2 |
Active Fault
• Fault is intermittent caused by poor contact in the sensor's and/or SCU connector or was repaired and SCU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to ("Verification Of Repair ") procedure.
History/Pending Fault
• Go to ("Wiring Inspection ") procedure.