Component Inspection

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

OBC/high voltage junction block install status inspection
Inspection Condition	Inspection Procedure	Reference
Review the troubleshooting guidelines thoroughly and repair the vehicle based on them. Wear insulated gloves, safety glasses, and insulated tools. Turn off the ignition switch and disconnect the ground cable attached to the battery fuse box. Disconnect "BMS Assembly_Main battery safety plug" and then wait for 5 minutes. Make sure the voltage between the high voltage terminals is below 30V.	Check the mounting bolts for high voltage connections between OBC and main battery pack.	-

Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the OBC and then go to "Verification Of Repair " procedure.

No Good

Carefully reinstall high voltage junction block and than go to "Verification Of Repair " procedure.