Monitor DTC Status

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	Inspection Procedure	Reference
1. Ignition "ON".	1. Connect KDS to "Data Link Connector (DLC)". 2. Monitor "Diagnostic Trouble Codes (DTC)" with KDS.	2. Monitor "Diagnostic Trouble Codes (DTC)" with KDS.

Courtesy of KIA MOTORS AMERICA, INC.

Active Fault

• Go to ("Wiring Inspection ") procedure.

• After disconnecting the CAN communication line, reconnect it and check that the same DTC is set.

• If the same DTC is not set, go to ("Verification Of Repair ") procedure.

History/Pending Fault

• Go to ("Verification Of Repair ") procedure.