DTC Description

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

P0A6500 is when the up/down switch of the drive motor W phase circuit in the drive motor inverter power module is turned "ON" at the same time due to error.

WARNING: Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage.
* Non-compliance with the following instructions can induce death or injury caused by electric shock.

Carefully read and follow service information instructions.
Wear insulated gloves, safety glasses and use insulated tools for your safety.
Turn the ignition switch off and disconnect ground cable of auxiliary battery and remove the safety plug.
Wait for more than 5 minutes so that the inverter capacitor can be naturally discharged.
Check high voltage terminal on power relay assembly is lower than 30V.
Per for Resolver adaptation alter the HPCU or the driver motor or the Hybrid Starter Generator (HSG) is replaced or reinstalled.
When replaced HPCU, Perform air bleeding for HPCU with KDS.