Info Code Of Freeze Frame Data

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	Inspection Procedure	Reference
Ignition "ON"	Connect KDS to Data Link Connector (DLC). Monitor "Diagnostic Trouble Codes (DTC)" with KDS. Select "Freeze Frame" of concerned DTC.	Table1 Fig.1

DIAGNOSTIC CODE DESCRIPTION

Separation	Info Code	Remark
Separation	Info Code	Remark
Save data when failure occurs	Info Code 1 = Airbag H/wire duty	Airbag H/wire duty ---- [%]
	Info Code 1 = Airbag H/wire duty	0 : Airbag CAN no receive 1 : Airbag CAN receive
	Info Code 2 = Airbag CAN receive or not (No: 0, Yes: 1)	0 : Airbag CAN no receive 1 : Airbag CAN receive

G14968940

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. Repair or replace as necessary and then Go to "Verification Of Repair " procedure.

No Good

Go to "MONITOR KDS DATA " procedure.