Circuit Inspection

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the auxiliary battery (-) cable. Remove the safety plug, and check that the high voltage terminal voltage is less than 30V. Disconnect the electrical connector(s) from the concerned component.	BMS coolant temperature sensor connector	Signal	Chassis ground	-	∞ (infinity)Ω
	BMS coolant temperature sensor connector	Ground	Chassis ground	-	Approx. below 1Ω

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair open or short in circuit and then Go to "Verification Of Repair " procedure.