LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento Plug-In Hybrid SX Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Control System Diagnosis (PHEV) (08 Of 10)) >> DTCP230C-00: Cylinder 3 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance >> System Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF" and disconnect fuel pump relay in junction box.
  2. Start the engine and wait until it stalls.
  3. Ignition "OFF" and connect fuel pump relay.
  4. Install the fuel pressure gauge to the delivery pipe using the fuel pressure gauge adaptor. (refer to shop manual)
  5. Activate the fuel pump, check for fuel leaks from the pressure gauge or fuel system.
  6. Measure the fuel pressure at idle.

    Specification : 

    Approx. 4.8 to 5.2 bar (480 to 520 kPa, 4.9 to 5.3 kgf/cm, 69.6 to 75.4 psi)

  7. Is the measured value within specifications?

Good 

• Go to ("Wiring Inspection ") procedure.

No Good 

• Repair as necessary and go to "Verification Of Repair .

scientia non olet · About LEMON Manuals