Component Inspection
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
| OTPS Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
OPTS (component side) | 2 (pressure signal) | OPTS (component side) | 1 (ground) | Table1 |
ENGINE OIL PRESSURE SENSOR - VOLTAGE SPECIFICATION
| Pressure | Output Voltage (V) | ||
|---|---|---|---|
| kPa | kg/cm2 | psi | |
| 50 | 0.5 | 7.25 | 0.5 |
| 1100 | 11.21 | 159.54 | 4.5 |
Good
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and Go to "Verification Of Repair " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the OPTS and Go to "Verification Of Repair " procedure.