Rear Active Purge Pump Sensor Inspection
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
| Rear Active Purge Pump Sensor Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
| 1. Ignition "OFF".2. Disconnect the electrical connector(s) from the concerned component. | Rear active purge pump sensor connector | 3 (power) | Rear active purge pump sensor connector | 1 (signal) | Approx. 14.5 ± 2Ω |
Good
• Go to ("Visual Inspection ") procedure.
No Good
• Carefully re-do this troubleshooting guide steps.
• If no problems were found with the circuits or connectors, replace the rear active purge pump sensor and go to ("Verification Of Repair ") procedure.