LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento Plug-In Hybrid SX Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Control System Diagnosis (PHEV) (02 Of 10)) >> DTC P0130-00: O2 Sensor Circuit (Bank 1/Sensor 1) >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
Item Detecting Condition Possible Cause
DTC Strategy Case 1
  • Check the voltage
  • Poor connector connection
  • Short circuit
  • Faulty upstream O2 sensor
Case 2
  • Rationality check, high side
Case 3
  • Rationality check, low side
Case 4
  • Rationality check (Stuck)
Enable Conditions Case 1
  • No fuel cut
  • Normal auxiliary battery voltage (10 to 16V)
  • Fuel system is close loop
  • Start engine and wait for 20s
Case 2 to 4
  • Fuel system is close loop
  • Integrated exhaust flow is higher than 1000g
Threshold Value Case 1
  • When heated oxygen sensor (B1S1) signal voltage is between 1.58V and 1.84V
Case 2
  • When heated oxygen sensor (B1S1) signal voltage is lower than 0.55V
  • When heated oxygen sensor (B1S2) signal voltage is higher than 0.75V
Case 3
  • When heated oxygen sensor (B1S1) signal voltage is between 0.7V and 1.80V
  • When heated oxygen sensor (B1S2) signal voltage is lower than 0.25V
Case 4
  • When heated oxygen sensor (B1S1) signal voltage is between 0.45V and 0.65V
Diagnostic Time
  • Continuously
MIL ON Condition
  • 2 driving cycles