LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Sorento Plug-In Hybrid SX Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (E-Shifter Diagnosis (PHEV)) >> DTC C1614-87: CAN Time-Out HCU/VCU/FCU >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF".
  2. Connect KDS to Data Link Connector (DLC).
  3. Ignition "ON".
  4. Monitor "Diagnostic Trouble Codes (DTC)" with KDS.
  5. Clear any DTCs stored in the system with KDS.
  6. Re-check DTC in the system with KDS.
  7. Did the same DTC is stored in the system?

    Good 

    • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary, go to "Verification Of Repair " procedure.

    No Good 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace control unit that causing the fault and then go to "Verification Of Repair " procedure.
scientia non olet · About LEMON Manuals