TPMS Fault Warning Lamp
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
- Warning Conditions and Display
- When the system detects a defect in the external operating environment (low battery voltage, abnormal vehicle speed, etc.), the warning lamp blinks for about 1 minute and then turns ON.
- Lamp OFF
- The warning lamp turns OFF when the DTC is resolved. The DTC is automatically resolved when the system does not receive any fault signals for 30 or more ignition cycles after it changes from the previous fault code.
CAUTION:- If this condition occurs while driving, you should check the cause of the fault even after the DTC is resolved. (Turn the ignition from OFF to ON. Then, check the lamp status.)
- The warning lamp turns off once the DTC is resolved. The warning lamp stays on until you complete the check necessary to resolve the DTC.
- If the DTC is resolved, the warning lamp turns OFF during the same ignition cycle.
CAUTION: If the vehicle starts within 19 minutes after the replacement of the wheel of the stopped vehicle, the TPMS Malfunction Indicator on the instrument cluster illuminates.- The above symptom is due to communication failure between the BCM and the replaced TPMS ID.
- This communication failure indicator turns off in 19 minutes after the vehicle stops through the BCM's automatic learning process of TPMS ID.
(When driving the vehicle after stopping for over 19 minutes, the indicator turns off automatically.)