Circuit Inspection
| CAN communication circuit Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
IEB module connector | 4 (C-CAN high) | Chassis ground | - | Fig.1 |
| IEB module connector | 5 (C-CAN low) | Chassis ground | - | ||
|
MDPS unit connector | 4 (C-CAN high) | IEB module connector | 4 (C-CAN high) | Approx. below 1Ω |
| MDPS unit connector | 5 (C-CAN low) | IEB module connector | 5 (C-CAN low) | Approx. below 1Ω | |
| MDPS unit connector | 4 (C-CAN high) | Chassis ground | - | ∞ (infinity)Ω | |
| MDPS unit connector | 5 (C-CAN low) | Chassis ground | - | ∞ (infinity)Ω | |
|
MDPS unit connector | 4 (C-CAN high) | MDPS unit connector | 5 (C-CAN low) | Approx. 60Ω |
Good
- Go to "Module circuit Inspection" procedure.
No Good
- Repair open or short in circuit and then Go to "Verification Of Repair " procedure.
| Module Circuit Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
MDPS unit connector | 2 (Memory power) | Chassis ground | - | B+ |
| MDPS unit connector | 1 (ground) | Chassis ground | - | Approx. below 1Ω | |
|
MDPS unit connector | 3 (ON/START Input) | Chassis ground | - | B+ |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and Go to "Verification Of Repair " procedure.
No Good
- Repair open or short in circuit and then Go to "Verification Of Repair " procedure.
- If no problems were found with the circuits or connectors, replace the MDPS unit and Go to "Verification Of Repair " procedure.