| DTC Strategy |
|
- Poor connector connection
- Open or short in power supply circuit
- Faulty battery
- Faulty IEB module
|
| Enable Condition |
- Ignition "ON"
- Auxiliary battery normal voltage (6.5 ~ 19V)
|
| Threshold Value |
Case 1 |
- When the valve relay is ON, valve relay voltage is below 5V is continues more than 165 ms
|
| Case 2 |
- When the valve is ON, the voltage difference between valve relay FET Drain and SOURCE is over 1±1.5V and that Case continue more than 165 ms
|
| Case 3 |
- When the valve is ON, the voltage difference between valve relay FET Drain and SOURCE is below 6±0.8V and that Case continue more than 165 ms
|
| Case 4 |
- If valve relay voltage is more than 6V continuously for more than 25 ms when relay is OFF
|
| Detecting Time |
Case 1 |
|
| Case 2 |
|
| Case 3 |
|
| Case 4 |
|
| Warning Lamp |
Case 1 to 3 |
- EBD, ABS, ESP, IEB, RBS, DBC, AVH, CHECK BRAKE (buzzer)
|
| Disable Condition |
- Ignition "OFF" and then "ON" after clear DTC and than reset valve
|