DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	CAN message monitoring	Poor connector connection Short or open in CAN line between IEB module and MCU Faulty MCU
Enable Condition	Ignition "ON" Auxiliary battery normal voltage
Threshold Value	Received CRC signal does not match the CRC calculated by IBAU maintain more than specific time
Detecting Time	In control: 500 ms Non control: 1500 ms
Warning Lamp	ESP, RBS, AVH, DBC
Disable Condition	Receive normal signal after ignition OFF and then ON more than 500 ms