Component Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Brake light switch connector | 1 (ON/START Input) | Brake light switch connector | 2 (stop signal) | ∞ (infinity)Ω |
| Brake light switch connector | 4 (Memory power) | Brake light switch connector | 5 (stop lamp signal) | Approx. below 1Ω | |
|
Brake light switch connector | 1 (ON/START Input) | Brake light switch connector | 2 (stop signal) | Approx. below 1Ω |
| Brake light switch connector | 4 (Memory power) | Brake light switch connector | 5 (stop lamp signal) | ∞ (infinity)Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then Go to "Verification Of Repair " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace brake light switch and then Go to "Verification Of Repair " procedure.